Real-world tips and process walkthroughs to help you make smarter manufacturing decisions—quickly and confidently.
When performing DFM analysis for injection-molded parts, we often find that designers overlook draft angles. It may seem like a minor [...]
Pure metals often offer good electrical conductivity, ductility, or corrosion resistance, but their strength, hardness, and heat resistance may not be [...]
If your product only requires a few hundred to a few thousand parts, is it worth investing in an injection mold? [...]
If you are designing an injection-molded part, you may quickly run into this problem: the wall thickness can no longer be increased, [...]
Have you often seen this advice: choose an aluminum mold for low-volume production and a steel mold for high-volume production? There [...]
In product design and manufacturing, part edges are rarely left as sharp right angles. Chamfers, fillets, and bevels all modify edge [...]
During ejection, an injection-molded part must overcome the gripping force caused by material shrinkage, friction between the part and the mold, [...]
In the periodic table, there is a group of elements that show some characteristics of both metals and nonmetals. These elements [...]
After reading our previous comparison of two-shot injection molding and overmolding, you may already have made your choice: if two-shot injection [...]
